![]() ![]() To go back to DOSBox screen use the same two keys. Once the game starts to load press the Alt and Enter keys simultaneously - this will put the game into full screen mode. To run the game, open D-Fend and do a right click on moon then a left click on RUN GAME. You shouldn't have to install the game again because you've already installed it from DOSBox. Make sure that DISK1 is in your F: drive and click OK again to complete the profile. Scroll down to the moon directory and do a single left click on it.Ĭlick on OK - you should now see the C:\moon in the Select Drive/CDROM/Image or floppy to mount: box. Now to mount your hard drive, which is C: drive.Ĭlick on Browse and find your drive (C) and do a double left click on it. Select Drive/CDROM/Image or floppy to mount:Ĭlick on Browse and find your CD Drive (F) and do a single left click on it.Ĭlick on OK - you should now have your F:/ drive in the Select Drive/CDROM/Image or floppy to mount: box.Ĭlick on Browse and find your CD Drive (G) and do a single left click on it.Ĭlick on OK - you should now have your G:/ drive in the Select Drive/CDROM/Image or floppy to mount: box. Open D-fend and Under Profile click Add with Editor.Ĭlick on the Environment tab and use the following settings:Ĭlick on the Sound tab and use the following settings:īehave intelligently - put a check in the boxĬlick on the Mounting tab and do the following: If you let me know what your CD-ROM letters are, and what drive you are using to install the moon directory, I can send you a complete profile to setup UAKM using D-Fend. Once the game is installed, open DOSBox and at the prompt type, cd moon ENTER then type, tex197 ENTER. ![]() Now you can setup UAKM by doing the following: Open DOSBox and after command prompt, enter f: (or d: if that is your CD-ROM drive letter) and type INSTALL. (Note: if your CD-ROM drives letters are 'D' and 'E' then replace the 'F' and 'G' above with 'D and 'E')Ĭlose the file being sure to save the changes. ![]() # Lines in this section will be run at startup. Use Notepad to edit the nf, replacing the section under the, at the very bottom of the page, with the following: Wherever you installed DOSBox, go there and open it. The easiest way to setup and run UAKM is to edit the dosbox conf file, as follows: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |